Before starting the installation of the software, a few pre-installation tasks need to be performed. These are:
If you are installing the software on the PC connected to the T3Ster equipment, make sure that the port address settings of the parallel interface card of T3Ster are correct (i.e. your Win32 operating system does not report any I/O port address conflict)
Decide where the root folder of the T3Ster software should be located. It is strongly advised to accept the default of the setup wizard (C:\MicReD\T3Ster), especially if you would like to install the THERMODEL program too.
If you are installing the T3Ster software on another computer (that is not connected to the T3Ster equipment), make sure that you have a valid license key file - otherwise the T3Ster software will refuse running.